Do you need to tap into the factory wiring harness of your Jeep Gladiator or Wrangler JL tail light so you can power the marker lights and 3rd brake light of a truck topper or camper?
Don’t tap the factory harness directly! Instead, buy our pig tail harness!
This harness plugs in between your factory wiring harness and tail light, and gives you 3 bare wires. One for the marker lights, one for the brake light and a ground.
We’ve clearly marked the bare wires so it’s easy to know what each wire is for.
This harness is extremely easy to install. Just:
- Remove the two screws securing the tail light and pull the tail light straight out.
- Disconnect the tail light from the factory harness.
- Plug our pig tail harness in between the factory harness and the tail light.
- Butt connect onto the provided wires in the pig tail harness and route those wires wherever you need.
It’s that easy!
When you no longer need the wire taps, just remove our pig tail harness and plug your factory harness back in directly to the tail light, and it’s like it was never there.
Super clean and takes all the risk out of messing with your factory wiring!